Qwood clip systems have been developed to help timber window manufacturers improve production efficiency, create a consistent finish and reduce the need for filling pin holes.
By removing the need for visible mechanical fixing, Qwood clips provide a clean, professional finish while helping manufacturers streamline their production processes.
As with any precision component, achieving the best results depends on using the correct installation method, tooling and settings.
This guide explains the key factors that help ensure reliable Qwood clip installation every time.
Traditional pinned beads require additional finishing work, including filling and sanding visible fixing points.
Qwood clip systems offer several advantages:
Many leading manufacturers use Qwood clip systems successfully, but correct installation technique is essential to achieve the best performance.
The recommended tool for installing Qwood clips is the OMER 80.16 pneumatic stapler or similar. OMER tools are recognised for their reliability, quality and long-term performance.
The OMER 80.16 features:
The recommended staples are:
One of the most common causes of clip damage is incorrect stapler setup.
The head of some staplers can interfere with the clip during installation. If this happens, the stapler head may need minor modification by carefully filing or removing material to provide the correct clearance. This allows the staple to drive correctly into the clip without damaging the clip. A correctly set-up tool should:
A common mistake is using the same air pressure setting as the CNC in the workshop. Many CNC air lines operate at approximately 8 bar pressure. However, Qwood clips should typically be installed using a reduced pressure setting of approximately 4 bar.
Excessive air pressure can cause the staple to drive too aggressively, which may damage the clip. For best results:
The correct pressure provides a clean installation while maintaining the integrity of the clip.
Temperature can also influence clip performance. When installing clips in colder workshop environments, particularly below 10°C, the material can become less flexible and more susceptible to damage. For optimum results:
This simple step can significantly improve installation consistency.
Before starting production, we recommend checking:
✅ Correct stapler – OMER 80.16 recommended
✅ Correct 80 Series staples fitted
✅ Stapler head clearance checked
✅ Air pressure reduced to approximately 4 bar
✅ Clips stored and installed at suitable temperatures
✅ Trial installation completed before full production
At Qwood, our aim is not just to supply a product, it is to help manufacturers achieve the best possible results from their production process.
With the correct tooling, settings and installation approach, Qwood clip systems provide a fast, reliable and professional alternative to traditional pinned beads.
If you need advice on Qwood clip installation, tooling recommendations or production setup, our technical team is always available to help.
Have a technical question?
Get in touch with our friendly team
